Dan's Jimny

front wheel bearing are easy

do i need a press to get them out? if so ill have to take the hubs to a garage and get them pressed iv ordered the tool aswell

mudman wrote: im geting the hump with it if im honest :laugh: evry time i do one thing i find somthing else that needs doing, i done the T-box and then found out that the cv's were up the wall so i done them and the kin pin bearings at the same time wich needed doing and the iner axle seal, then i find out that the wheel bearings need doing there on order from BigJimny shop (i may need a hand with them if your around) iv got my front arms on and shocks and stil got the rear arms to do then its a bit of wealding in the boot new tyres then MOT time

Yeah but it's all good fun though :laugh: :laugh: :laugh:

mudman wrote: do i need a press to get them out? if so ill have to take the hubs to a garage and get them pressed iv ordered the tool aswell

yer a press is needed

Mudman, that’s always the way though. But sooner or later you will have it all done and you can get out and enjoy!!!

Just don’t let it turn in to a project that never reaches the road or mud in this case! I restored a Mini a few years ago but never ended up getting it on the road, it was gutting selling it but I just realized I didn’t have the time or money to get it on the road. Every now and then I think why didn’t I just keep it :pinch: :pinch: :pinch:


Before


And 3 years and lots of blood, sweat and tears later...

dont worry im not sell it any time soon ill never get my money back on it and ill be back to square one :lol: