A place for general chat about the Jimny. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.

Suppliers/Dealers or anyone selling with a commercial view in mind CANNOT post here unless responding to a specific request of a member in a "wanted" post.

Suppliers include people "breaking for spares" on a regular basis, when purchasing spares members should ask a supplier what they contribute to the running of the forum particularly if contacted by a Private Message

Suppliers or Members who have contributed to the forum can be identifed by the
logo.

What did you do to your jimny today?

More
02 Jul 2019 17:03 #210516 by Riccy
Nice work B)

The blanking button is for heated seats I think :unsure:

J999 MNY, ULYSSES M18 VVT with ITB's Dyno tested at 130hp

Pickup/tipper, R7me gearbox & 6.4 Rocklobster, 31" Toyo MT, 2x ARB air locker 3.9 diffs in braced axles, 6" total lift, Floating rear conversion, Raptor painted, CB, Recaro's, Caged, etc, etc...

www.youtube.com/user/riclemus

Please Log in or Create an account to join the conversation.

  • stiffsteve204me
  • Visitor
  • Visitor
    Public
03 Jul 2019 12:14 #210546 by stiffsteve204me
Replied by stiffsteve204me on topic Re:What did you do to your jimny today?
Drove it in a neep field. :lol: :lol:






Steve.

Please Log in or Create an account to join the conversation.

More
04 Jul 2019 21:35 #210636 by Max Headroom
A very neat looking solution to your light-bar switch Scimike.

Today I finally fitted a fastback roof on mine. I'd bought it a while ago and its been sitting around. but I needed to get the main hood off the car to do some repairs to it;. the monsoon hoods are ok, but they arent great.

For anyone thinking of a fastback roof, If you have small kids, they can still use the seats in the back but the headrests will be need to be taken out. An adult would find it cramped.

My main reason for fitting this is that its much less fabric to fold up when you want the roof open, and as my name Max Headroom implies, I like the roof open a lot! I also think it looks quite funky when the roof is up :) B)



IF IT AINT BROKE, KEEP FIXING IT UNTIL IT IS

Please Log in or Create an account to join the conversation.

  • Lambert
  • Offline
  • Moderator
  • Moderator
    Registered
  • The quickest Jimny in Harrogate...(that I own)
More
05 Jul 2019 03:53 #210644 by Lambert
Very smart.

Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
ADOS Attention Deficit Ooooh Shiny!
The following user(s) said Thank You: Max Headroom

Please Log in or Create an account to join the conversation.

More
06 Jul 2019 15:15 #210716 by Max Headroom
Thanks Lambert

There seems to be slightly less wind-noise with this fitted compared to the standard hood


IF IT AINT BROKE, KEEP FIXING IT UNTIL IT IS

Please Log in or Create an account to join the conversation.

More
06 Jul 2019 17:18 #210718 by Scimike
Like the look of the fastback, never seen one, nice.

Yokohama Geolanders, Sony head unit, NAUTILUS Air Horn, DRL conversion, Rear cargo space, Elvis Bobblehead, transfer Guard, Indian hanging Elephant, Koni Heavy track dampers, Custom SS exhaust, Voodoo Doll, Adventure Rack with LED ight bar, vintage ERIBA caravan usually attached (yes it's slow)

Please Log in or Create an account to join the conversation.

  • Daniel30
  • Visitor
  • Visitor
    Public
06 Jul 2019 18:44 #210722 by Daniel30
Replied by Daniel30 on topic Re:What did you do to your jimny today?
Very neat and tidy

Please Log in or Create an account to join the conversation.

More
06 Jul 2019 19:29 #210723 by Max Headroom
A little more restrictive in the rear :ohmy: but I'm wondering it will also help the cockpit warm up quicker in winter


IF IT AINT BROKE, KEEP FIXING IT UNTIL IT IS

Please Log in or Create an account to join the conversation.

More
06 Jul 2019 23:47 - 06 Jul 2019 23:48 #210733 by Scimike
Finished wiring my light bar via the Ariel route.
I had to use a thinner cable first fed from the top as a "path finder", then I pulled the final cable in from the bottom. It enters the car just above the front driver side speaker. Hole in mount sealed with Cyno glue as the drilled hole was a nice tight fit to the cable.

The only negative is this route puts the power cable in close proximity to the Ariel (obvious), so I can hear the diode switching buzz slightly on the FM radio. Not an issue for me as I stream / MP3 my music, but one to note if anyone else wants to take this route.

I have at work some thin Stainless steel flexible conduit, so planning to make a cosmetic cover to protect the cable further and maybe experiment with it as a RF shield to reduce or eliminate the noise on FM.

Final cable entry point


Test drive, full main beam (150% brighter bulbs) at play here, so brighter than standard.


And then add the light bar, same bit of road, no camera tricks
That will do, pleased with that

Yokohama Geolanders, Sony head unit, NAUTILUS Air Horn, DRL conversion, Rear cargo space, Elvis Bobblehead, transfer Guard, Indian hanging Elephant, Koni Heavy track dampers, Custom SS exhaust, Voodoo Doll, Adventure Rack with LED ight bar, vintage ERIBA caravan usually attached (yes it's slow)
Last edit: 06 Jul 2019 23:48 by Scimike.

Please Log in or Create an account to join the conversation.

More
07 Jul 2019 06:01 #210739 by Riccy
Scimike... I know its a bit late now, but you could look at a shielded power cable to reduce the noise on the FM aerial...




Hell of a difference with the lightbar on, looks good :-)

J999 MNY, ULYSSES M18 VVT with ITB's Dyno tested at 130hp

Pickup/tipper, R7me gearbox & 6.4 Rocklobster, 31" Toyo MT, 2x ARB air locker 3.9 diffs in braced axles, 6" total lift, Floating rear conversion, Raptor painted, CB, Recaro's, Caged, etc, etc...

www.youtube.com/user/riclemus
Attachments:

Please Log in or Create an account to join the conversation.

More
07 Jul 2019 06:17 - 07 Jul 2019 06:18 #210741 by mlines
Use ferrite clip on supressors. Had the same problem with LED lighting taking out VHF radio channels on my boat

. www.amazon.co.uk/Topnisus-Anti-interfere...a-401643989907&psc=1

Sent from my Pixel 2 XL using Tapatalk

Martin

2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Last edit: 07 Jul 2019 06:18 by mlines.

Please Log in or Create an account to join the conversation.

  • stiffsteve204me
  • Visitor
  • Visitor
    Public
07 Jul 2019 08:07 #210744 by stiffsteve204me
Replied by stiffsteve204me on topic What did you do to your jimny today?
Hell of a difference with the light bar, Scimike. Well worth the effort.



Steve.

Please Log in or Create an account to join the conversation.

Time to create page: 0.923 seconds
Joomla template by a4joomla