One of the most common upgrades people want to do to their Jimny is to lift it. This can be for a number of reasons varying from "the look" through to fitting large tyres or replacing a tired suspension. We like the look of a slightly perkier Jimny, not a soaring lift but just enough to make it look a bit more purposeful.

I sell the Trailmaster 50mm lift kit in the BigJimny store which gives that extra lift without going too far. In particular, it does not require the spacers on the front cross member that other kits seem to need.

I have videoed the experience and the videos are below......

Over the past few months I have been carrying out some little modifications/upgrades to our Gen4 Jimny and created some video guides.......

I have embarked on building my own low ratio transfer box. I have previously built two boxes, one for my SJ and one for my Jimny but both of these were 4:1 boxes built using the "Difflock" cut & shut gears. This is a frequently maligned process but the current Jimny one has served nearly 10 years so far so they cannot be too bad, however with 32" tyres it is time for something more low range.

Since I did the cut & shut one, a variety of aftermarket gearsets have appeared that provide a "drop in" solution with pre-cut gears. There are a variety available from cheap Chinese versions through to Japanese manufactured ones made in the original factory.

I went for the Trail-Gear 6.5:1 set as it represents a mid priced solution that has been on sale in the USA for a number of years. This should bring back the gearing quite nicely on the road whilst providing a very low gearing off-road.

Also needed is a Suzuki SJ transfer box, either a 410 or 413 will do (except for the very early 410 versions which are useless). See the section in the Wiki - HERE - which tells how to identify the correct box. Late 413 boxes are particularly good as they have the same larger flanges that the Jimny has, however it is straight forward to drill the old ones if necessary.

If you are doing this from scratch you will also need mounting arms, propshafts and a speedo adaptor to fit it to a Suzuki Jimny. Of course, I already have those parts on my as it has a 4.1:1 Transfer box already fitted.

So the build begins......BigJimny's Transfer box.

​This three part article covers my building of a RockLobster 6.5:1 transfer box. The article parts are:

• Part 1 - Dis-assembly (see HERE)
• Part 2 - Building the gears (this part)
• Part 3 - Re-assembly. (see HERE)

The kit I am using (Trail Gear) contains gears and parts to replace/add to an SJ Transfer box. Within an SJ transfer box are effectively three gearsets/shafts as follows:

• Input shaft - The Trail Gear set contains a replacement shaft to which you add either the original bearings or new bearings as you prefer,

• Counter shaft - The Trail Gear set contains a replacement shaft and gearset to drop in,
• Output shaft - The Trail Gear set contains replacement gears for the original gears, you either re-use the original bearings or new bearings as you prefer.

​This three part article covers my building of a RockLobster 6.5:1 transfer box. The article parts are:

• Part 1 - Dis-assembly (see HERE)
• Part 2 - Building the gears (HERE)
• Part 3 - Re-assembly (this part)