×
A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Miss fire
Less
More
- Posts: 37
- Thank you received: 0
- Points: 0.00
29 Jul 2008 21:50 #87
by Dave N
Got jimny going again after my trip into the deep water changed ecu and some other bits and pices. It has developed intrmitend miss fire think it could be water in fuel going to drain it tomorrow. ticks over perfect on acceleration it misses then clears if any one has any ideas what i could check could you send reply. Thanks... Had water in gearbox fr diff and power stearing fluid. wont be going near water again.
Please Log in or Create an account to join the conversation.
30 Jul 2008 08:48 #89
by mlines
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Replied by mlines on topic Re:Miss fire
If the fuel doesn't sort it then I would suspect one of the sensors such as the O2 sensor. But if there is no fault code on the dash board then its not going to be easy to find.
Martin
Martin
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Please Log in or Create an account to join the conversation.
Time to create page: 0.067 seconds