× A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.

Jimny Gen4 JB74 Exhaust Manifold

More
17 Jul 2022 17:09 #244118 by vise
Hi. I am looking for the specified tightening torque for the exhaust manifold bolts and nuts for the Jimny Gen4 JB74.
Are the values the same for both the bolts and nuts?
I do not have the workshop manual so would appreciate these values as I am about to fit a different manifold.
Regards Gerrit
 

Please Log in or Create an account to join the conversation.

More
17 Jul 2022 18:35 #244121 by mlines
Main manifold bolts and nuts - 60Nm
Stiffener bolt and nuts - 25Nm

The stiffener is the bracket at the neck of the manfold to engine block

Martin

2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses

Please Log in or Create an account to join the conversation.

Time to create page: 0.083 seconds
Powered by Kunena Forum

I hope you enjoy using this forum. Please consider making a donation towards the upkeep of this forum website.

We use cookies to give you the best online experience. Please let us know if you agree to all of these cookies. Accepting the Cookies also accepts the Disclaimers for the website.