A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
I have just created
this wiki article
about this specific gearbox swapping procedure.
The article is just an introduction which needs further expansion.
It would be very beneficial if all those who have performed this swapping procedure would contribute by expanding the article and making it into a proper guide (for example, like
this wiki guide
.
Last edit: 11 Apr 2018 15:42 by Bosanek. Reason: Typo
Bosanek wrote: I have just created
this wiki article
about this specific gearbox swapping procedure.
The article is just an introduction which needs further expansion.
It would be very beneficial if all those who have performed this swapping procedure would contribute by expanding the article and making it into a proper guide (for example, like
this wiki guide
.
Will do
I should have mentioned that there is a difference in the spline count on the output shaft of the two gearboxes, meaning they cannot be interchanged without swapping props about as well.
J999 MNY, ULYSSES M18 VVT with ITB's Dyno tested at 130hp
Bosanek wrote: I have just created
this wiki article
about this specific gearbox swapping procedure.
The article is just an introduction which needs further expansion.
It would be very beneficial if all those who have performed this swapping procedure would contribute by expanding the article and making it into a proper guide (for example, like
this wiki guide
.
Had a go. Typed a load of stuff and it just wont have it. Keeps saying logout and try another browsing tab? wont have it when i do that
J999 MNY, ULYSSES M18 VVT with ITB's Dyno tested at 130hp
I opend my box today everything looks fine
It looks to be opened before and the reverse gear plastic shimm was in the wrong place but it still gives a little trouble to go into 1st gear but it surely does work better
Jay-t wrote: I opend my box today everything looks fine
It looks to be opened before and the reverse gear plastic shimm was in the wrong place but it still gives a little trouble to go into 1st gear but it surely does work better
