A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Undoing crank pulley bolt?
30 Jan 2016 02:04 - 30 Jan 2016 02:06 #161471
by facade
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Replied by facade on topic Undoing crank pulley bolt?
Incidentally, my jimny had started to make A Noise when revved hard in first gear to pull away sharply, a sort of graunchy buzzy howl, just like a worn needle roller in the gearbox. (I was going to buy a set of bearings and rebuild the gearbox when I do the clutch this Summer, I'd checked for loose heatshields and stuff already))
It seems to have stopped now, and I notice at least half of the rubber left on the pulley is all polished :whistle:
It seems to have stopped now, and I notice at least half of the rubber left on the pulley is all polished :whistle:
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Last edit: 30 Jan 2016 02:06 by facade.
Please Log in or Create an account to join the conversation.
- Daniel30
- Visitor
-
Public
30 Jan 2016 08:40 #161475
by Daniel30
Replied by Daniel30 on topic Undoing crank pulley bolt?
Glad you have finally got it sorted
Well done in turning your pain into other people's gain by writing up a great thread about the problem
Well done in turning your pain into other people's gain by writing up a great thread about the problem
Please Log in or Create an account to join the conversation.
30 Jan 2016 09:01 #161476
by facade
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Replied by facade on topic Undoing crank pulley bolt?
Cheers,
If I'd known the old one was breaking loose, I could have run superglue round the splitline and repaired it. while it was still on
still, If I'd known how easy chopping the washer off would make it I'd have just bought the new bolt and had it changed a week ago :whistle:
If I'd known the old one was breaking loose, I could have run superglue round the splitline and repaired it. while it was still on
still, If I'd known how easy chopping the washer off would make it I'd have just bought the new bolt and had it changed a week ago :whistle:
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Please Log in or Create an account to join the conversation.
- mickt
- Visitor
-
Public
- gusthegorilla
- Visitor
-
Public
- SOTA
- Visitor
-
Public
Time to create page: 0.139 seconds