Wheelarch inner liners

When you guys have trimmed away your arches to fit bigger wheels what have you done to refit the inner liners to prevent mud going up through the void.

Any pics?

Nice i need to know this too

how do you guys fix bumpers back as the bolt hole gets cut away

Yes the same is true of the arch liners because as you cut away the arch on the wing you also cut away the liner fixing holes.

I drilled 4 holes in the bottom of the bumper and 2 holes in the liner, then fed a cable tie up and through the liner and back through the bumper. This holds it away from the wheel. Did this on each side.

I haven't done that myself just yet, but I'm gonna do it in a few weeks hopefully, because I hate how mud and sand gets into every gap. It even comes out between the fender and the headlight!

I've been thinking about this, and have a few ideas already. I'm going to try to use the original inner liners if possible, but I'm prepared to make those liners myself out of some rubber mat if the original liners can't be adapted...

I'll try get some pics when I get them done!