LED bar/spot wiring?

I have put several extra wires through the main grommet by taping the wire on to the end of a small cross-hatch screw-driver or knitting needle and a cable just pushes through next to the main loom, no need to cut another hole.

If you are running thick cables, put a thin one through first and use it as a draw cord. If you use a red wire, it is easy to see, especially if access is difficult.

Robin

Thanks. Actually got the wiring completed yesterday.

Removed the 12v for access and cut the tape off of that large grommet. The tape is very sticky and the rubber very soft. I did slightly cut part of the flange of the grommet while trying to get the tape off. But it hasn’t caused any issues.

Got the switch wired in. I didn’t bother with the lighting circuit as that meant finding another wire splicing into it. Also it is rather annoying that despite the switch matching the factory style. It lights up blue rather than orange!