another Jimny from AU!

Correct, there is no problem with the hubs being locked all the time.

Fitted up my snorkel today. Was worried when I started the car again I had a check engine light but then I realised I forgot to plug the O2 sensor back in lol. Nice induction note but there is a slight whistle/hum at idle. Ah well you get what you pay for eh!



Also took my roofrack off for a lick of paint and light bar mounts.

Took rear seats out and started taking measurements. Was thinking I could possibly take the side plastics off to give more room? The only downside I could think of was road noise.

Planning on getting new tyres soon (thank god) I'm looking at Kumho KL71s, reasonably cheap and good tyre from what I've heard?

Sounds like you have been busy

If you taking all the rear seats etc out, get some good sound proofing and cover as much as you can

that would be a good idea. Went and bought the materials for my rear draws yesterday, now just need some time to make them! Was thinking I could incorporate my 12V compressor and dual batteries into the draws as well as the sound system. Ill need to remeasure and see if i have enough room

Considering making a roof console with left over ply. I found this online but I'm not sure how id go mounting it to the roof, may need a nutsert tool. I suspect it would have to be very low profile for me not to hit my head on it lol


went for a flex pose yesterday, not too bad for stock i was actually surprised!

Looking good mate, to be honest it will probly flex even further .

Let there be light!



Was easy enough to wire up, but jeez negative switching is a pain! ah well got it done. Ran the wiring through the aerial.

The light output from these things is phenomenal, so much spread.