×
A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
greasing wheel bearings
15 Oct 2008 07:43 #219
by mlines
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Replied by mlines on topic Re:greasing wheel bearings
Baz,
You can do it but it only gives you very limited access. By removing the hub nut (see www.bits4vits.co.uk for the tool) you can access the front of the bearing as shown below (you can just see the bearing hidden below the pin I am using to drive it out.
However the bearing is around 5cm (2 inches) in depth (its at least a double ball race) and if you look in the picture below which is taken from behind you can see the second race. Therefore pushing grease in the front to lubricate the back is not going to be easy
You can do it but it only gives you very limited access. By removing the hub nut (see www.bits4vits.co.uk for the tool) you can access the front of the bearing as shown below (you can just see the bearing hidden below the pin I am using to drive it out.
However the bearing is around 5cm (2 inches) in depth (its at least a double ball race) and if you look in the picture below which is taken from behind you can see the second race. Therefore pushing grease in the front to lubricate the back is not going to be easy
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Please Log in or Create an account to join the conversation.
Time to create page: 0.078 seconds