× A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.

are they all the same

  • vitara_mad
  • Topic Author
  • Visitor
  • Visitor
    Public
07 Mar 2011 14:02 #12765 by vitara_mad
are they all the same was created by vitara_mad
are all jimny sohc engines the same ???

thinking of taking one out of a soft top w reg & fitting it into a hard top w reg

they look same but just thought i would check first to make sure there is not some slight differance that will cause it not to run in the hard top jimny

thanks

Please Log in or Create an account to join the conversation.

More
07 Mar 2011 14:05 #12766 by mlines
Replied by mlines on topic Re: are they all the same
I believe that in all the major components they are the same. There may be some minor component changes here and there but in the major physical components they are identical.

Martin

2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses

Please Log in or Create an account to join the conversation.

More
07 Mar 2011 17:13 #12775 by facade
Replied by facade on topic Re: are they all the same
There have been some posts about missing sensors, the hard top will be a Japanese built car, the soft top Spanish, this might make a difference.

If it suddenly breaks, go back to the last thing that you did before it broke and start looking there :)

Please Log in or Create an account to join the conversation.

  • vitara_mad
  • Topic Author
  • Visitor
  • Visitor
    Public
07 Mar 2011 20:20 #12781 by vitara_mad
Replied by vitara_mad on topic Re: are they all the same
so is there anything i need to look for to make sure there the same & have same sensors & whatknott

Please Log in or Create an account to join the conversation.

More
07 Mar 2011 21:41 #12794 by facade
Replied by facade on topic Re: are they all the same
Look at the sensors fitted to the hard top cam, crank or both together, and make sure the soft top has the same.

I'm sure I read posts about having to change the oil pump housing between engines to solve this problem.

If it suddenly breaks, go back to the last thing that you did before it broke and start looking there :)

Please Log in or Create an account to join the conversation.

  • vitara_mad
  • Topic Author
  • Visitor
  • Visitor
    Public
07 Mar 2011 22:34 #12799 by vitara_mad
Replied by vitara_mad on topic Re: are they all the same
thanks for the tips will have a look & hope they are same if not then it wont be getting swapped over as dont want to be changing engine parts about.

Please Log in or Create an account to join the conversation.

More
08 Mar 2011 13:57 #12829 by wildfire
Replied by wildfire on topic Re: are they all the same
Some soft-tops have a different downpipes and cats on them than the two in the manual. They only produced these for a few months between 2000 and 2001 according to the local garage.

Please Log in or Create an account to join the conversation.

Time to create page: 0.108 seconds
Powered by Kunena Forum

I hope you enjoy using this forum. Please consider making a donation towards the upkeep of this forum website.