×
A place for general chat about the Jimny. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Suppliers/Dealers or anyone selling with a commercial view in mind CANNOT post here unless responding to a specific request of a member in a "wanted" post.
Suppliers include people "breaking for spares" on a regular basis, when purchasing spares members should ask a supplier what they contribute to the running of the forum particularly if contacted by a Private Message
Suppliers or Members who have contributed to the forum can be identifed by the
logo.
Suppliers/Dealers or anyone selling with a commercial view in mind CANNOT post here unless responding to a specific request of a member in a "wanted" post.
Suppliers include people "breaking for spares" on a regular basis, when purchasing spares members should ask a supplier what they contribute to the running of the forum particularly if contacted by a Private Message
Suppliers or Members who have contributed to the forum can be identifed by the
How-To: Jimny Spotlight Wiring
01 May 2013 18:11 #69817
by JerseyJimny
How-To: Jimny Spotlight Wiring was created by JerseyJimny
I was struggling to wire up the relay for the Jimny due to the Japs wiring them up weirdly!
Found these two wiring diagrams which saved the day!
This is the normal way you would wire spot lights up
And this green one is the way you wire up Jimny spotlights
Only one more note is to take the feed for the relay of the dipped beam feed
If your not sure then take out the plug that goes into the back of the blub and poke the wire for the feed to the relay in each of the three plugs then flash the high beam... If they come on with the high beam and come off when the high beam dose then you have found the correct source!
Hope this helps
JJ
Found these two wiring diagrams which saved the day!
This is the normal way you would wire spot lights up
And this green one is the way you wire up Jimny spotlights
Only one more note is to take the feed for the relay of the dipped beam feed
If your not sure then take out the plug that goes into the back of the blub and poke the wire for the feed to the relay in each of the three plugs then flash the high beam... If they come on with the high beam and come off when the high beam dose then you have found the correct source!
Hope this helps
JJ
Please Log in or Create an account to join the conversation.
01 May 2013 20:45 #69833
by little jimny
Replied by little jimny on topic How-To: Jimny Spotlight Wiring
Nice find! Thanks for sharing that 
Please Log in or Create an account to join the conversation.
Time to create page: 0.069 seconds