A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
I have a 1999 JB33W Jimny, When I checked the 16 pin OBD2 like connector, I see pin 7 and 9 has wires. When I check the wiring diagram, it shows only 1 wire connected to pin 9 from ECM (I checked). I'm wondering where the other k-line wire (pin 7) is connected to. Usually k-line wire should be at 12v at rest, but it is not reading any voltage (0v) Anyone has any ideas ?
