Gen 3 Boot Rust

Hello all!

I bought a suzuki Jimny about 3 months ago - 2002, 90k miles. Runs really well and I absolutely love it. I somewhat recently put in some speakers in the rear where the factory holes go and during the process, you have to remove the rear seats. I used this as an opportunity to check and take a picture of the rust in the boot section. There is a bit of dirt in here (I cleaned it after the photo was taken but forgot to retake a photo before i put it back together) but I wanted to see if anyone has an opinion on the rust spots? The previous owner said that they welded part of the rear of the boot (I assume where the wheel jack goes) but I can see a couple of rust spots near-ish the seatbelt anchors. 

What I am trying to deduce is, will this rust cause any problems for safety, and if I need to get the rust spots removed and welded? Or if the rust won’t cause any affect to safety so therefore it isn’t of concern yet?

Photo

https:// www.icloud.com/iclouddrive/03bUAoR2PrR4ye2q8y8jOGXyQ#Jimny_Boot

Any opinions would be greatly appreciated

Cheers, Dan

 

The picture is not visible.
Might be for Apple users but closed as is now.

Pictures can be up loaded to this site, use the full editor, press attachments, add file, insert.

Hope I can find a better explanation to link here

Hi mate, thank you for letting me know - I’ve attached it using your instructions - let me know what you think if you wouldn’t mind

It's not the worst I have ever seen but I would be looking at getting it dealt with if it were mine.

While it's still quite small patches with seemingly good metal around it is the best time to deal with it. Wire wheel on a drill will clean it up and if it doesn't make a hole then you're laughing, just a paint job. If it does then it needs patching

Treat with a rust inhibitor before painting with ordinary car paint, unless you use a paint with rust inhibitor built in.

They generally rust from the inside, but check the outside as well.

Robin