A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Gen 3 - Engine Stalling at low revs - Service Bulletin
Looking through the Suzuki Jimny bulletins, I found this one from March 2019 for Gen3 Jimnys (so the bulletin was released after the Gen3 was discontinued). I believe it applys to all Jimnys from 2008 but it may evne extend to 2005 (introduction of the VVT)
"Engine stalling may occur when pulling away from standstill using minimal accelerator pedal input."
This applies to both Manual and Automatic vehicles. If you think your Jimny stalls too easily then there is a software update for ECU,
This aoplies to ECU:
33920-76JB*
33920-76JC*
33921-76JA*
33921-76JB*
33921-76JL*
33921-76JM*
33922-76J7*
33922-76J8*
33922-76JG*
33922-76JH*
As ALL gen3 are out of warranty this upgrade would cost you, It is timed as a 40 minute activity on the Bulletin.#
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
