A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
getting hot....
- rexthecat
- Topic Author
- New Member
-
Less
More
- Thank you received: 0
10 years 9 months ago #161970
by rexthecat
getting hot.... was created by rexthecat
...on long slow hills, went to a very muddy pay and play site few weeks ago, thought I'd done a decent job cleaning the rad out but on the long slow hills over Sth Downs today needle went up to about 3/4, never gone over 1/2 before. Does that just sound like the rad needs a bit more of a clean?
Got to go sort it out just building up to it, was up at 5 to go get the wheel bearing sorted.
ta
Got to go sort it out just building up to it, was up at 5 to go get the wheel bearing sorted.
ta
Please Log in or Create an account to join the conversation.
10 years 9 months ago #161982
by facade
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Replied by facade on topic getting hot....
I'd check the rad again.
Could be blocked with mud, or you could have jet washed it and flattened all the fins so air can't get through.
Could be blocked with mud, or you could have jet washed it and flattened all the fins so air can't get through.
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Please Log in or Create an account to join the conversation.
- rexthecat
- Topic Author
- New Member
-
Less
More
- Thank you received: 0
10 years 9 months ago #161990
by rexthecat
Replied by rexthecat on topic getting hot....
Yeah hoping just mud, given it a good clean (in place) hopefully that will do it, changing the thermostat looks a rest pain on this engine
Please Log in or Create an account to join the conversation.
Time to create page: 0.108 seconds
