Handbrake light stays on.

the brake warning light serves both the handbrake and also the fluid level.. try this:

1. Disconnect connector from brake fluid reservoir - if problem goes you have a faulty sensor or fluid level problem

if problem persists

2. Disconnect connector from handbrake - If the problem goes the switch is the likely culprit
3. short the two connectors in the plug - if the brake light comes on on the dashboard then the wiring is fine and the switch is definitely the cause (give it a spray with WD-40 as it might be wet).

If its still not working then its either the ignition switch or ABS if you have it fitted.

from the manual

Cheers for all the replies. The fluid level, brake pads etc are fine so I'll follow yellowstreak's advice and see what comes up.

Its the ignition switch theres is so iv been told on here a black bit that causes it iv never had the problem so cant be 100% on the black bit but in sure 100% its the ignition switch

AS Mark says, it can be the ignition switch

Yellostreak's diagram shows a connection to the ignition switch that earths the bulb out when in the starter position (probably a bulb test) the VR coloured wire on the left (violet with red trace?)

If disconnecting the handbrake switch and the reservoir switch don't work, disconnect that wire from the ignition switch (I don't know if anything else connects to it that isn't in the diagram though)

mine has been flashing recently lately as well, i disconnected the cable that was coming out of the brake fluid pot and it dissapeared! time to top up my brake fluid

Mine disappears if i waggle the key a bit !

just replaced all the fluids and it still comes on