A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.

CV joint cost?

  • doncarlyon
  • Visitor
  • Visitor
    Public
21 Sep 2011 16:51 #22284 by doncarlyon
Replied by doncarlyon on topic Re: CV joint cost?
£400... bloody hell... where did you get that done? Suzuki?

Please Log in or Create an account to join the conversation.

  • Nobby22
  • Topic Author
  • Visitor
  • Visitor
    Public
21 Sep 2011 16:58 #22285 by Nobby22
Replied by Nobby22 on topic Re: CV joint cost?
No. :laugh: I used a local garage. Compared to what Suzuki would have charged me i think £400 wasnt to bad. :laugh:. I am just pissed off about the wrong grease being used. Thanks to someones complete bloody stupidness i've had to pay for something that should'nt have had to be done. :angry:

Nobby

Please Log in or Create an account to join the conversation.

  • doncarlyon
  • Visitor
  • Visitor
    Public
21 Sep 2011 17:07 #22286 by doncarlyon
Replied by doncarlyon on topic Re: CV joint cost?
So what did they actually replace for the £400?

2 CV joints?

Please Log in or Create an account to join the conversation.

  • unsure
  • Visitor
  • Visitor
    Public
21 Sep 2011 17:50 #22290 by unsure
Replied by unsure on topic Re: CV joint cost?
sounds bloody expensive to me too....
I woul dhave just packed more good grease in, would of prob lasted a while yet....

Please Log in or Create an account to join the conversation.

  • Nobby22
  • Topic Author
  • Visitor
  • Visitor
    Public
21 Sep 2011 17:54 #22292 by Nobby22
Replied by Nobby22 on topic Re: CV joint cost?
£150 for 3 hours labour
£208 for two c.v. joints. So thats £104 each. :dry:
£10 sundries

Total £441.60

Please Log in or Create an account to join the conversation.

More
22 Sep 2011 17:15 #22354 by mlines
Replied by mlines on topic CV joint cost?
Remember that Suzuki do not do separate CV's they replace the whole driveshaft which means it will always be expensive.

-- Sent from my HP TouchPad using Communities

Martin

2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses

Please Log in or Create an account to join the conversation.

Time to create page: 0.135 seconds
Joomla template by a4joomla
We use cookies to give you the best online experience. Please let us know if you agree to all of these cookies. Accepting the Cookies also accepts the Disclaimers for the website.