What did you do to your jimny today?

Changed throttle bodies over, she's now fixed

Thanks again j999pre

Got carried away with my angle grinder and cut my reinforced kap bumper off

Nathan126 wrote: Changed throttle bodies over, she's now fixed

Thanks again j999pre

Glad it sorted you out nathan. Cheers

shopped for new tires.

gaz3359 wrote:

GWR wrote:

gaz3359 wrote: fitted a 2" lift kit and budget steering damper well happy with the results,did a little write up in my jimny thread although its nothing yous havnt seen before.

to

Looking good mate

Did you get anywhere with the memory map stuff?

Thanks mate,tbh i put a few of the pda's in my watch list on ebay but forgot about bidding on them,i need to get me one as it will be handy bit a kit.

In that case do you have an android smartphone coz if you do you can download a memory map app and a map for all the UK is only around £12 so it's a bargain! The app used to be pretty naff but it's now much improved so you might want to give it a go. I have downloaded it and it seems similar to the original version.

Found a leaking swivel even though I only did the kingpins and inner seal less than 1000 miles ago grrrrr!

Tried to fit my transfer box guard. One of the TB mount bolts was so rusted and seized that in my attempt to get it off the bushing seperated from its base plate :dry:

Now need to get a new set of TB bushes

I finally got around to painting the front trim from KAP that I put on the Jim in December!

Sent from my HTC Sensation XE with Beats Audio Z715e using Tapatalk 2

after two great days off-roading in The Lake District, I suspected my Front N/S Bearing was shagged ... but both Wheel Bearings and King Pin on both N/S and O/S are perfect, as are both CV's -- BUT, sadly all PandHard Tie Rod ends and Steering Tiue rods ends are worn - new ones ordered from Big Jimny.

Next weekend, its time to look at Rear Wheel Bearings, Half shafts and Brake shoes.

Then do an Oil and Filter change and renew Diff Oils.

GuardianAngel wrote: Tried to fit my transfer box guard. One of the TB mount bolts was so rusted and seized that in my attempt to get it off the bushing seperated from its base plate :dry:

Now need to get a new set of TB bushes

I'll look out for that when I eventually fit mine GA ...................

Not today, but 2 weekends ago (only just got round to posting it!)

Kingpins, both sides, went well. Bottom one was harder to get out on both sides, not sure why?!

Also replaced rear brake shoes, again both sides. I snapped the nose on a brand new set of Halfords Professional pliers trying to get the big springs back on too! Fortunately the lifetime guarantee was honoured and a new set was given in exchange with no quibble

Collected the parts from Martin and had a nice chat. Thanks!

I intended to fit all my new TB mounts, change the TB oil seal from the rear prop and fit my new TB guard. Pathetically, I could only get one mount off and one new one on :blush:

Everything was seized, then it started to p155 hard and blow a gale. So I packed up and went back indoors :whistle:

Will try again tomorrow evening...