2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Hello! I need two sets of these bolts (4 on each side), there seems to be only one set in the shop. Ideally would need them for next weekend. Any chance to get them till then? Thank you.
Well I did have more in stock so I updated the quantity and they promptly sold to someone.
I will try and get some more
Sorry
Martin
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
I've tried local motor parts shop, but they haven't had the right size in stock and told me that the spline is there for a reason, so I assumed there is something specific about the bolts that I might not see first, which stopped me from getting some similar bolts from a hardware shop. Yours actually have no spline either.
Do these bolts have any special features, that untrained eye won't see, or can normal bolts be used instead?
Mine do not have the spline. As far as I am aware the spline is effectively a built in star washer, so I include a star washer with my bolts. Should be back in stock on Wednesday.
In the original bolt the "spline" is only on the face of the bolt head, not to be confused with "Spline bolts" which have the spline on the shaft and are typically specialist application bolts such as wheel hub bolts.
A quote from a bolt supplier.....
Armed with teeth-like serrations, serrated flange bolts are one-piece bolts bite into surfaces to resist vibration. This bolt is identifiable by the ridge or surrounding the bolt head, this built-in washer under the head of the Bolt acts to distribute the clamping load over a greater area. A flange bolt is designed to provide the same holding power as a washer.
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
