Help needed Identifying the correct cv joint?

Not been on the forum for ages as real life took over again but I’m hoping to dip into the knowledge on here to help me again.

I’m running out the door heading to work so don’t hate me if there is a similar post that I missed over breakfast

Q. Can you identify spline/ ball combo of the CV fitted to the car from the year (57 plate 2008) or engine identification (16v m series)? Or do i need to remove the driveshaft? I need the car for daily transport so don’t really want to put it off the road to find out what cv I need. The plan is to order the parts and have them sitting for my week off at the end of the month and do the repair then.

Any help/ advice on suppliers would be much appreciated.

That is again in advance for any help given.

Tony


Sent from my iPhone using Tapatalk

Whats the registration number (PM me if you do not want to put it here)

It’s cool. J 70NY T
Thanks Martin.


Sent from my iPhone using Tapatalk

My system shows it as being a

8 balls, 26 external splines and 29 internal splines CV - Suzuki part 44102-84A00

This one in the store

www.bigjimny.com/store/cv-joint-type-2.html

I have a "pre-opened" one of these (sent to a customer, tried it but it didnt fit his car, covered in oily fingerprints but never used) for £50 if you do not mind the opened box.

mlines wrote: My system shows it as being a

8 balls, 26 external splines and 29 internal splines CV - Suzuki part 44102-84A00

This one in the store

www.bigjimny.com/store/cv-joint-type-2.html

I have a "pre-opened" one of these (sent to a customer, tried it but it didnt fit his car, covered in oily fingerprints but never used) for £50 if you do not mind the opened box.

Sounds good. I’ll pm you later this evening when I’m home from work. Much appreciated.


Sent from my iPhone using Tapatalk

Successfully installed the CV Joint today. Pity the kingpin bearings need replaced too. Martin if you read this check your messages please. Tony.


Sent from my iPhone using Tapatalk