A place for general chat about the Jimny. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Suppliers/Dealers or anyone selling with a commercial view in mind CANNOT post here unless responding to a specific request of a member in a "wanted" post.
Suppliers include people "breaking for spares" on a regular basis, when purchasing spares members should ask a supplier what they contribute to the running of the forum particularly if contacted by a Private Message
Suppliers or Members who have contributed to the forum can be identifed by the
logo.
Suppliers/Dealers or anyone selling with a commercial view in mind CANNOT post here unless responding to a specific request of a member in a "wanted" post.
Suppliers include people "breaking for spares" on a regular basis, when purchasing spares members should ask a supplier what they contribute to the running of the forum particularly if contacted by a Private Message
Suppliers or Members who have contributed to the forum can be identifed by the
Gearbox/Transfer Case/Diff Breathers - Ingredients
- jackonlyjack
-
- Offline
- Platinum Member
-
Registered
15 May 2019 22:04 #208064
by jackonlyjack
Replied by jackonlyjack on topic Gearbox/Transfer Case/Diff Breathers - Ingredients
You need 1/8 bsp tapered tap
2 x 1/8 bsp to 6mm push fit elbows for axles
gear box R7ME two ways of doing it 8mm to 6mm reducer
push the 8mm part into the rubber sleeve that comes from G box
Or i used this way pulled the sleeve off the box and replaced it with some rubber tube from the vac hub system.
around 6" long pushed onto the G box stub used a hose spring clip from vac system
then pushed the 6mm pneumatic tube around 2" then another hose clip
pneumatic tube front axle up to manifold on bulk head,G box also up to manifold,rear axle up to manifold with a 6mm equal T piece
which goes to T box (i have SJ transfer box) so can not give any advice on standard T box fitment
Jack
2 x 1/8 bsp to 6mm push fit elbows for axles
gear box R7ME two ways of doing it 8mm to 6mm reducer
push the 8mm part into the rubber sleeve that comes from G box
Or i used this way pulled the sleeve off the box and replaced it with some rubber tube from the vac hub system.
around 6" long pushed onto the G box stub used a hose spring clip from vac system
then pushed the 6mm pneumatic tube around 2" then another hose clip
pneumatic tube front axle up to manifold on bulk head,G box also up to manifold,rear axle up to manifold with a 6mm equal T piece
which goes to T box (i have SJ transfer box) so can not give any advice on standard T box fitment
Jack
Please Log in or Create an account to join the conversation.
Time to create page: 0.138 seconds