What did you do to your jimny today?

High Bridge 1st rear bumper installed + tow bar removed. 

   

Fitted the BigJimny DRL LEDs, thanks Martin.  Also fitted a CarMate phone holder, which is a JDM accessory I got from Amazon. It replaces the fascia panel between the air vents and the stereo, adds two more "novelty bolts" and the phone holder can be attached to either of them (being over 50 and presbyopic, I obviously have it on the furthest one!).  Means I can use Google Maps for navigation without spending a fortune on a new head unit.  It was only £25, which is remarkable given the hideously bulky phone holders sold for £50 and more on some sites.  They even bothered to.match the plastic colour and texture to the Jimny dash.

amzn.eu/d/f6fEtp0

Thanks for mentioning this. Just bought one!

The instructions are all in Japanese but it's fairly obvious

How does it match up when fitted? Does it look OEM or aftermarket with colour and texture?

I'll post a photo later but it's pretty good.

Filipao wrote:

High Bridge 1st rear bumper installed + tow bar removed. 

 

 

What is different about this bumper from the original? Thanks.

It looks like it sits a bit higher than the original. I can't see the exhaust on mine and the stock bumper fits close to the tow bar.

The High Bridge looks like it is a bit higher, may be as much as 75mm?

Robin

The light clusters are more inset on the Highbridge, maybe designed for a Kei car conversion?

On our models the light clusters is further out in line with the edge of the wheel arch.

Pics of the phone holder.

20240314_164948 by rogerzilla , on Flickr

20240314_164958 by rogerzilla , on Flickr

20240314_165008 by rogerzilla , on Flickr

20240314_165017 by rogerzilla , on Flickr

Domo-kun approves.

20240314_165037 by rogerzilla , on Flickr
 

Thanks, looks a very good match.

Lil Red ventured out in the poor weather (I was crying inside) but she’s with the detailer for some final correction polishing and ceramic coating. Will pick it up in a couple of weeks.