Font size: +
1 minute reading time (116 words)

24/10/10 - Welding up the Axle

I had a few hours free today to move it on a bit.


If you recall the mounting holes in one of the Leading Arm mounts were worn oval. Therefore I needed to sort out a repair. This was pretty straightforward. I got hold of some 12mm Repair Washers and ground off the plating (its poisonous to weld them)


I then bolted them in the hole, lined it all up and welded around them. This was the first weld which was not too clean, but I cleaned them up and welded them in a bit better.

Once they were properly welded up, I then painted them up with some primer and a final coat.

6/11/2010 - Fitting the leading arms
22/10/10 - The Parts have arrived
We use cookies to give you the best online experience. Please let us know if you agree to all of these cookies. Accepting the Cookies also accepts the Disclaimers for the website.