A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.

Crank pulley bolt torq spec m13a

More
14 Nov 2024 19:35 #258304 by Jimbob
Crank pulley bolt torq spec m13a was created by Jimbob
Hi all, new here.
have had to make a account to seek help for repair my jimny tomorrow morning.
the crank pulley failed. Got old one off and new one ready to go with a new bolt but can’t find the torq anywhere.

please help. 
2006 1.3 m13a vvt.

 

Please Log in or Create an account to join the conversation.

More
14 Nov 2024 19:43 #258305 by facade
Replied by facade on topic Crank pulley bolt torq spec m13a
150Nm. You might need to make a locking tool that picks up on the two threaded holes in the centre and clamps against the face of the pulley.

If it suddenly breaks, go back to the last thing that you did before it broke and start looking there :)

Please Log in or Create an account to join the conversation.

More
14 Nov 2024 19:52 #258306 by Jimbob
Replied by Jimbob on topic Crank pulley bolt torq spec m13a
Thank you so much for the quick reply and the information.
I modified a large spanner to remove it. Hoping I can reuse the modified spanner to tighten again
Wish us luck.
Thanks again

Please Log in or Create an account to join the conversation.

More
15 Nov 2024 15:45 #258328 by auchenblae
Replied by auchenblae on topic Crank pulley bolt torq spec m13a
Best of Luck
eddie

16 SZ3
07 JLX+ gone 16
99 JLX gone 07

Please Log in or Create an account to join the conversation.

More
16 Nov 2024 19:01 #258345 by Rogerzilla
Replied by Rogerzilla on topic Crank pulley bolt torq spec m13a
www.bigjimny.com/index.php/forum/7-jimny...shaft-pulley-failure

150Nm, it says there.  So more than a wheel nut.  I am assuming this is for dry threads, with a new bolt.

Double and triple check the Woodruff key is properly located before tightening.

Please Log in or Create an account to join the conversation.

Time to create page: 0.141 seconds
Joomla template by a4joomla