A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.

Jimny 1.3 non vvt to 1.6 non vvt conversion

More
15 May 2023 21:46 #249127 by Stevekennedy
Jimny 1.3 non vvt to 1.6 non vvt conversion was created by Stevekennedy
Hey guys I’ve got a 1.6 non vvt liana engine to pop in the jimny. 
what parts do I need to swap over? complete list please guys. Any help is greatly appreciated 

 

Please Log in or Create an account to join the conversation.

  • Lambert
  • Offline
  • Moderator
  • Moderator
    Registered
  • The quickest Jimny in Harrogate...(that I own)
More
16 May 2023 03:27 #249128 by Lambert
Replied by Lambert on topic Jimny 1.3 non vvt to 1.6 non vvt conversion
It's basically a long block swap. Everything else is retained. There's information in the Jimny information section on the top banner.
Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
ADOS Attention Deficit Ooooh Shiny!

Please Log in or Create an account to join the conversation.

More
16 May 2023 08:34 #249133 by Dured
Replied by Dured on topic Jimny 1.3 non vvt to 1.6 non vvt conversion
I think this has been discussed in great detail here and on a certain Australian forum, probably search by key words "Jimny Conversion M13 to M16"
But I swapped over: block, head, injectors, intake manifold with TB (except the ICV). Rest is jimny from m13a: Dipstick, rocker cover, sump, oil filter stud, ICV, Exhaust manifold, spark plugs, coils, flywheel etc.
I would suggest replacing engine and gearbox mounts since engine and most likely gearbox will be out. Maybe clutch as well if you see its below 50%.

Please Log in or Create an account to join the conversation.

Time to create page: 0.146 seconds
Joomla template by a4joomla