A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Hi
i have a 2006 Jimny with the usual rot in the rear boot well, seatbelt anchorage points.
ive spotted a 2005 car in the local scrap yard with a rust free boot floor(hard to believe)
my question is how easy is it to cut the good floor out?
I can make cuts all the way round but is it welded to the chassis underneath and if so whereabouts?
I know that I can buy a replacement panel but I was hoping to save a few quid
I’d be astonished if it’s welded to the chassis. Watch out for anything below (fuel tank) and then whip it out with 1mm slitting discs would be my approach!
