A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
I''ve put a Vitara Auto Box on a G Series Jimny Engine using the Vit Flex Plate.
It ran OK for a while, then started making a clattering noise which tracked down to the flex plate bolts being loose (where they screw in to the crank shaft).
Two weeks ago, I took the engine out replaced the bolts, tightened them as specified in the service manual and used LocTite thread-lock.
However, after one outing - they have come undone again! This is somewhat aggravating!
Has anyone heard of this being a problem? Is there a solution?
I guess I could cross-dril the bolts and wire them - but I would rather find out why it's happening in case it's a symptom of something else!
Thanks for the Nord-Lock tip - I'll give it a go!
What I'm wondering though is, what is causing it in the first place! The alignment appears to be good - I can't see any obvious reason for the problem!
