A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Remote locking fob
- darthloachie
- Visitor
-
Public
18 Sep 2010 14:39 #4715
by facade
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Replied by facade on topic Re:Remote locking fob
You have a fob???
Never seen one. However there is a section in the manual, may be the battery dead, or the remote needs synchronising with the car. It is supposed to be part of the key.
REPLACEMENT OF TRANSMITTER BATTERY
If transmitter becomes unreliable, replace transmitter battery as
follows.
1) Remove screw (1) and transmitter cover (2).
2) Remove transmitter (3) from transmitter holder (4).
3) Put edge of coin or flat blade screwdriver in slot of transmitter
(3) and by pry it open.
4) Replace the battery (lithium disc-type CR1616 or equivalent
battery) so its + terminal faces “+†mark on transmitter.
5) Fit together transmitter (3) and install it into transmitter
holder (4).
6) Install transmitter cover (2) and screw (1).
7) Make sure the door locks can be operated with transmitter.
CODE REGISTRATION PROCEDURE
If transmitter or door lock controller replace new one, register key
code as follows.
1) Confirm that the vehicle is the following conditions.
• All doors are closed.
• Ignition key is out of ignition switch.
• Driver side door is unlocked.
2) Disconnect negative (-) cable from battery.
3) After 30 seconds, perform the following procedure within 60
seconds.
a) Connect negative (-) cable to battery.
b) Operate driver side door knob switch from lock to unlock.
c) Push “LOCK†button on transmitter and confirm that are
operated from lock to unlock.
d) Push driver side door knob switch to lock position.
e) Push “LOCK†button on transmitter twice and confirm that
all doors are operated from unlock to lock. With this, code
registration is completed.
Never seen one. However there is a section in the manual, may be the battery dead, or the remote needs synchronising with the car. It is supposed to be part of the key.
REPLACEMENT OF TRANSMITTER BATTERY
If transmitter becomes unreliable, replace transmitter battery as
follows.
1) Remove screw (1) and transmitter cover (2).
2) Remove transmitter (3) from transmitter holder (4).
3) Put edge of coin or flat blade screwdriver in slot of transmitter
(3) and by pry it open.
4) Replace the battery (lithium disc-type CR1616 or equivalent
battery) so its + terminal faces “+†mark on transmitter.
5) Fit together transmitter (3) and install it into transmitter
holder (4).
6) Install transmitter cover (2) and screw (1).
7) Make sure the door locks can be operated with transmitter.
CODE REGISTRATION PROCEDURE
If transmitter or door lock controller replace new one, register key
code as follows.
1) Confirm that the vehicle is the following conditions.
• All doors are closed.
• Ignition key is out of ignition switch.
• Driver side door is unlocked.
2) Disconnect negative (-) cable from battery.
3) After 30 seconds, perform the following procedure within 60
seconds.
a) Connect negative (-) cable to battery.
b) Operate driver side door knob switch from lock to unlock.
c) Push “LOCK†button on transmitter and confirm that are
operated from lock to unlock.
d) Push driver side door knob switch to lock position.
e) Push “LOCK†button on transmitter twice and confirm that
all doors are operated from unlock to lock. With this, code
registration is completed.
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Please Log in or Create an account to join the conversation.
Time to create page: 0.132 seconds