A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Ball joint splitter
- Sponnie
- Visitor
-
Public
04 Oct 2012 22:04 #49521
by Sponnie
Replied by Sponnie on topic Ball joint splitter
I knocked the kingpin bearing races out using a socket. Its was an impact socket, can't remember the size but I dropped it in then used the socked extensions bar and wacked the race out 
You may have problems getting the nut off the ball joint, use a wire brush on the thread as this is where the nut can get stuck and start turning the tapered bolt.
You may have problems getting the nut off the ball joint, use a wire brush on the thread as this is where the nut can get stuck and start turning the tapered bolt.
Please Log in or Create an account to join the conversation.
- markyp2000
- Visitor
-
Public
Time to create page: 0.113 seconds