A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
ebay - I don't do them as I cannot get them as cheap as they go on ebay.
Martin
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
i'm going to try and clean them up again but done this a couple of times now and still get a bit gunge and leakage coming through
going to check the kingpins again and replace if necessary, ordered a new set so i have them if they're needed.
if i could get a cheap (ish) set of seals i'd do those aswell.
will keep an eye out on ebay
They didn't come in time for me to change them though so they'll get done the next time, apparently they didn't get the email from ebay so they weren't sent out until i contacted them.
well i got the hubs and seals off tonight so will have a better look tomorrow to see if they're worth cleaning up.
got to the bottom of why i'm gettin gunge leaking from the swivel.
both kingpins had become separated from the holding plate, snapped. got some replacements to go on, also some new bearings so should all go together when i find time. if the swivel seals need replacing i'll order some from ebay
cheers
