A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
2-good tyresplus 2-partworns
wanderinstar
Topic Author
Visitor
Public
12 Dec 2011 05:50 - 12 Dec 2011 05:51#27952by wanderinstar
Yesterday i was given the above Colways.My question is where do I fit them on the vehicle.Don't anyone say "on the hubs" :laugh:
Do I put the good tyres on the front to pull the vehicle over obstacles or on the rear to push over obstacles.
Alternative;y do I mix them on each axle, to avoid spring wind-up.The thinking being that with no centre diff there would be a differing rolling radius on each axle.
Ian.
I would put the good ones on the back to prevent lift off oversteer on the road
If you are in 4wd then the surface should be mud or snow - ie slippy so you shouldn't get wind up and better grip at the back to push
What tread are they? if they're the old colway mt's then they are the same pattern as technic trackers iirc. Just if you wanted to get some better ones to replace the part worns.
