A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Jimny front discs
03 Apr 2011 13:01 #14401
by kangooman
Jimny front discs was created by kangooman
Hi
Could you tell me if there are different discs for the later Jimny (mines a 2007).
I went to replace the discs and pads today, but the discs would not go over the hub.
I've looked online to see if there different sizes but as far as I can see all Jimnys have the same size discs.
The centre hole in the new discs are 107mm, but like a donkey I didn't measure the old disc center hole.
I've cleaned all the hub etc, but no way will the new disc fit.
Cheers
Richard
Could you tell me if there are different discs for the later Jimny (mines a 2007).
I went to replace the discs and pads today, but the discs would not go over the hub.
I've looked online to see if there different sizes but as far as I can see all Jimnys have the same size discs.
The centre hole in the new discs are 107mm, but like a donkey I didn't measure the old disc center hole.
I've cleaned all the hub etc, but no way will the new disc fit.
Cheers
Richard
Please Log in or Create an account to join the conversation.
- adamjimny
- Visitor
-
Public
03 Apr 2011 13:34 #14403
by adamjimny
Replied by adamjimny on topic Re: Jimny front discs
im sure they are all the same.
the disc is a tight fit i used a rubber mallet to gently tap it into place so it sits flush
the disc is a tight fit i used a rubber mallet to gently tap it into place so it sits flush
Please Log in or Create an account to join the conversation.
03 Apr 2011 13:38 #14404
by kangooman
Replied by kangooman on topic Re: Jimny front discs
I can confirm that the center hole in my disc is 108.5mm hence the new discs wont fit being 107mm.
it was bugging me so much I just went out and whipped the disc off again
I bet I'll have to fit genuine discs knowing my luck :evil:
Cheers
Richard
it was bugging me so much I just went out and whipped the disc off again
I bet I'll have to fit genuine discs knowing my luck :evil:
Cheers
Richard
Please Log in or Create an account to join the conversation.
03 Apr 2011 13:40 #14406
by mlines
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Replied by mlines on topic Re: Jimny front discs
They are different sizes.
Early Jimny discs up to VIN 203804 have 107mm diameter holes.
From VIN 203804 onwards the holes are 108.3 mm
Therefore a new series disc will fit an old car, but an old series disc will not fit a new car.
Martin
Early Jimny discs up to VIN 203804 have 107mm diameter holes.
From VIN 203804 onwards the holes are 108.3 mm
Therefore a new series disc will fit an old car, but an old series disc will not fit a new car.
Martin
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Please Log in or Create an account to join the conversation.
- adamjimny
- Visitor
-
Public
03 Apr 2011 13:48 #14407
by adamjimny
Replied by adamjimny on topic Re: Jimny front discs
learn something new everyday
but that sucks for you
but that sucks for you
Please Log in or Create an account to join the conversation.
03 Apr 2011 13:48 #14408
by kangooman
Replied by kangooman on topic Re: Jimny front discs
Martin thanks for cofirming that I thought it was me going mad
Would you know if there is and aternative naufacture for these discs/ or will I have to use Genuine?
Cheers
Richard
Would you know if there is and aternative naufacture for these discs/ or will I have to use Genuine?
Cheers
Richard
Please Log in or Create an account to join the conversation.
03 Apr 2011 14:18 #14411
by facade
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Replied by facade on topic Re: Jimny front discs
get someone with a big lathe to bore them out to 108.5mm, or turn your hubs down to 107mm. (might cause a problem with OE alloy wheels though, they may locate on the centre)
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Please Log in or Create an account to join the conversation.
03 Apr 2011 15:01 #14419
by mlines
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Replied by mlines on topic Re: Jimny front discs
ADL-Blueprint list them
Earlier 107mm disks - adk84305
Later 108.3 mm disks - adk84325
Earlier 107mm disks - adk84305
Later 108.3 mm disks - adk84325
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
The following user(s) said Thank You: kangooman
Please Log in or Create an account to join the conversation.
03 Apr 2011 16:35 #14428
by kangooman
Replied by kangooman on topic Re: Jimny front discs
Thanks for all your help guys.
I will order some of the correct ones tomorrow
Cheers
Richard
I will order some of the correct ones tomorrow
Cheers
Richard
Please Log in or Create an account to join the conversation.
04 Apr 2011 16:49 #14476
by kangooman
Replied by kangooman on topic Re: Jimny front discs
All sorted today thanks to you guys.
A nice new set of adk84325 blueprint discs and were back on the road.
They don't make things like they used to do they? My Jimny is 3yrs 4 mths old and only done 9500 miles and here I am changing discs. They probably rusted because the jeep sits outside my house doing nothing for most of its life.
I Bought it at 10 mths old with only 1900 miles on the clock, so its had an easy life.
Thanks again for your help.
Cheers
Richard
A nice new set of adk84325 blueprint discs and were back on the road.
They don't make things like they used to do they? My Jimny is 3yrs 4 mths old and only done 9500 miles and here I am changing discs. They probably rusted because the jeep sits outside my house doing nothing for most of its life.
I Bought it at 10 mths old with only 1900 miles on the clock, so its had an easy life.
Thanks again for your help.
Cheers
Richard
Please Log in or Create an account to join the conversation.
Time to create page: 0.167 seconds