A place for general chat about the Jimny. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Suppliers/Dealers or anyone selling with a commercial view in mind CANNOT post here unless responding to a specific request of a member in a "wanted" post.
Suppliers include people "breaking for spares" on a regular basis, when purchasing spares members should ask a supplier what they contribute to the running of the forum particularly if contacted by a Private Message
Suppliers or Members who have contributed to the forum can be identifed by the
Yes it's quite straightforward there is even a removable plate in the floor for the lever. However the gearing will be lower as the lever box will be 1.3 to 1 in high not 1 to 1. What are the symptoms that make you think that the electronics are at fault?
Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
ADOS Attention Deficit Ooooh Shiny!
Drive shaft differences too isn't it before and after 2005?
I would not be surprised if it was possible to put a gen4 handle assembly where the gen3 actuator is on the Tcase but other than general optimism i have no knowledge if it can be done.
Cannot get 4x4 to engage. Electri motor runs, it's been bench tested, control buttons on dash have been tested and are okay, unsure if the vacuum controlled hubs are working or not
When there is a vacuum problem the lights on the dash will flash and tell mostly.
Lack of vacuum will result in no engagement and a flashing light when you push the bottom. Could be a leak most likely, but also other faults.
logo.
