A place for general chat about the Jimny. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.

Suppliers/Dealers or anyone selling with a commercial view in mind CANNOT post here unless responding to a specific request of a member in a "wanted" post.

Suppliers include people "breaking for spares" on a regular basis, when purchasing spares members should ask a supplier what they contribute to the running of the forum particularly if contacted by a Private Message

Suppliers or Members who have contributed to the forum can be identifed by the
[img
logo.

rear axle

More
07 Apr 2023 16:10 - 07 Apr 2023 16:14 #248425 by mag
rear axle was created by mag
Hi all , this is going to sound dumb !!

standard 04 jimny , no lift , the rear drivers side appears to sit 3cm lower than passenger side ( measured from bottom of wheel arch lip )
and the right hand rear wheel appears to have moved a few cm to the left ! top of the wheel appears to be further in than the bottom.

Nothing obvious appears broken , snapped or bent , any ideas what to look at in greater detail

Drives fine by the way !!
Last edit: 07 Apr 2023 16:14 by mag.

Please Log in or Create an account to join the conversation.

More
07 Apr 2023 17:53 #248428 by Scimike
Replied by Scimike on topic rear axle
If you can jack the body up so that it lifts the vehicle and extends the rear suspension. This involves jacking from the bodywork/ chassis, so please be careful if you get underneath. Once it's lifted have a good look at each spring and axle / body mounts for damage. Check the spring ends for missing coils or cracks etc.
ITS possible the Jimny has a natural lean, but ours is perfectly level so not sure why some report this. So my suggestion is based on looking for damage rather than if a lean is correct or not.
 
Yokohama Geolanders, Sony head unit, NAUTILUS Air Horn, DRL conversion, Rear cargo space, Elvis Bobblehead, transfer Guard, Indian hanging Elephant, Koni Heavy track dampers, Custom SS exhaust, Voodoo Doll, Adventure Rack with LED ight bar, vintage ERIBA caravan usually attached (yes it's slow)
The following user(s) said Thank You: mag

Please Log in or Create an account to join the conversation.

  • Lambert
  • Offline
  • Moderator
  • Moderator
    Registered
  • The quickest Jimny in Harrogate...(that I own)
More
07 Apr 2023 19:08 #248429 by Lambert
Replied by Lambert on topic rear axle
Tend to agree with the above, 30mm is a lot for there not to be a snapped coil spring.
Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
ADOS Attention Deficit Ooooh Shiny!
The following user(s) said Thank You: mag

Please Log in or Create an account to join the conversation.

More
08 Apr 2023 08:43 #248433 by jackonlyjack
Replied by jackonlyjack on topic rear axle
Does it have the standard pan hard rod ?
check the upper spring mounting points
also pan hard mounting point at chassis end and the U channel diagonal from
pan hard up to chassis cross member   
My Jimny
www.bigjimny.com/index.php/forum?view=topic&catid=8&id=60814

www.youtube.com/channel/UCfJa3cPPDZYGwkWr0rvu8ug
The following user(s) said Thank You: mag

Please Log in or Create an account to join the conversation.

Time to create page: 0.150 seconds
Joomla template by a4joomla