An area for non Suzuki Jimny related chat. Keep it clean etc. as this is a public forum with young readers.
Fao Andy2640 and other AFOLs
Less
More
- Posts: 9049
- Thank you received: 1811
18 May 2019 17:52 #208280
by Lambert
Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
ADOS Attention Deficit Ooooh Shiny!
Replied by Lambert on topic Fao Andy2640 and other AFOLs
Yeah but it's only a little on from the 80s that my dad got. I would like a proper old one but have yet to find one I like condition wise.
Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
ADOS Attention Deficit Ooooh Shiny!
Please Log in or Create an account to join the conversation.
- Andy2640
- Visitor
-
Public
18 May 2019 18:34 #208281
by Andy2640
Replied by Andy2640 on topic Fao Andy2640 and other AFOLs
What tools do you chaps carry in your jim? Or other bits n bobs? and dont say babywipes
Please Log in or Create an account to join the conversation.
- Andy2640
- Visitor
-
Public
18 May 2019 18:48 #208283
by Andy2640
Got them, next
Replied by Andy2640 on topic Fao Andy2640 and other AFOLs
GeorgeC wrote:
A space-saving water-carrier that the Aus. Army uses is the trusted latex Condom!Andy2640 wrote: What tools do you chaps carry in your Jimny? Or other bits n bobs? And don't say baby-wipes
Got them, next
Please Log in or Create an account to join the conversation.
18 May 2019 19:22 #208286
by facade
I've got some folding snips that I still use. These are dated 1917, but apparently, there were so many made in 1917 that they could have been issued as late as the 1950s.
They are general purpose cutters, whereas yours are proper wire cutters for barbed wire.
I have quite a few tools older than me, that I inherited from my late father, and he got them second hand. I'm still using a Blackhawk 1/2" drive 15" cracker bar from 1941.
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Replied by facade on topic Fao Andy2640 and other AFOLs
Lambert wrote:
I've got some folding snips that I still use. These are dated 1917, but apparently, there were so many made in 1917 that they could have been issued as late as the 1950s.
They are general purpose cutters, whereas yours are proper wire cutters for barbed wire.
I have quite a few tools older than me, that I inherited from my late father, and he got them second hand. I'm still using a Blackhawk 1/2" drive 15" cracker bar from 1941.
If it suddenly breaks, go back to the last thing that you did before it broke and start looking there
Please Log in or Create an account to join the conversation.
Time to create page: 0.232 seconds