Didn't realise the shop appeared to not know I had some!
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
ta for the bolts. just a quick one should the top shock bolts screw all the way in, they both seem to screw in the same leaving about 8mm gap, im thinking they are screwing in up to were the old bolts were and i need to tap the hole right through so the bolts can come through the other side.thanks for any info.
No i aint,will put some on, there will still be a gap the bolts only going in less than 3/4 of the way in the threds i just thought the hole would have been tapped right through,dose any one know the pitch of the thread is it 1 or 1.5,ta, thinking of just running a tap down them.
