Re:Gen4 power door locks

Hi

Dose anyone know how the power door locks work on the new jimny

Do the work of Can cummunication or 12v signal

I had a look at my drivers side lock and it has 5 wires coming out of it i had assumed 2 for the lock motor a commmon and a contact for lock and unlock

I am looking for the signal sent back to the BCM from the lock and unlock

any help would be great

Thanks Mate

Thats good to know I will try that out later on see how we go.

Had a look at the wiring as suggested

And it seem to look fin on the meter

However bridging the black and red or purple did not seem to trigger the central locking not sure why as this is what the key seems to do

Had a look at the wiring as suggested

And it seem to look fin on the meter

However bridging the black and red or purple did not seem to trigger the central locking not sure why as this is what the key seems to do

Yes I would say your right wonder if there is any other way to trigger the lock and unlock

If it was me l'd hook in a separate new circuit to power the locks. Protect the existing wiring using diodes where necessary. A proper wiring diagram should help.
Martin? Chris.

Yes you are correct I did want to avoid this but I ended up makeing a circuit to power the lock diectly and retain the factory function using 3 DTDP relays and 2 Diodes. and Finaly my new system is installed with push button start and pasive key entry.