Our 1986 SJ "Leafer" has an ARB. Mounts to the spring mounting plates and the front crossmember
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Is there much difference in the road handling? I’m on OME lift springs and Muds so I can’t imagine it’s going to have much if anything in the way of vehicle dynamics…
I took mine off my S3 a couple of years ago after it started snapping the mounting bracket off the axle. And then repeatedly snapping so I was being left with more weld than bracket.
I don't race around anywhere but I really didn't notice any difference on road.
I suspect it's an MOT failure if the MOT man notices. So don't go leaving nice clean sections of chassis where you unbolted it!
Although anti roll will also be down to the spring and damper setup. Assuming the setup is quite flexy, I find it baffling that people say they can't notice a difference on road....
