Gen4 - rocking side to side at speed
- Posts: 778
- Thank you received: 325
Car was full loaded, two adults, one teen, luggage in car and roofbox. We've travelled with an identical setup before over thousands of miles and never experienced this.
I shifted all the weight in the roofbox down into the car which improved things slightly, but it was still doing it to some extent, even with the roofbox removed.
If I didn't know better, I'd think some of my shocks had failed - but they're OME units that are only a few years old, so seems unlikely? If I bounce the car when stationary it stops after one bounce which seems normal.
Tyres were at 28psi. Don't know if relevant but it only started after the last Jimny meet - could I have damaged something?
It's driving me mad. Any ideas?
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
If I recall correctly rear tires take a higher pressure when the vehicle is fully loaded, I don't recall what it is, and my wife is out with the JB so I can't just run out & check it - the JC takes 29 at the rear fully loaded, but I don't really see being 1psi low as making a huge difference to stability.
It certainly wasn't "wobble of death", wobble of death, if you ever experience it, is an unforgettable event - a violent shaking of the steering wheel, and only to get out of it, is to bring the vehicle to a stop.
What you're describing sounds more like a top heavy vehicle, they tend to "wallow" as you steer into the sway, you're always lagging the event, I have experienced something similar but not a Jimny.
Please Log in or Create an account to join the conversation.
- Posts: 778
- Thank you received: 325
Could there be any mud stuck behind the wheel making it unbalenced or lost weights from the wheels?
No significant mud, but hadn't considered weights, I'll have a look, thanks.
Please Log in or Create an account to join the conversation.
- Posts: 778
- Thank you received: 325
How fast were you going and how much weight did you have on the roof? Is the front stabilizer (anti sway) bar still fitted and what condition are the mounts & end links in? What tires are you running?
If I recall correctly rear tires take a higher pressure when the vehicle is fully loaded, I don't recall what it is, and my wife is out with the JB so I can't just run out & check it - the JC takes 29 at the rear fully loaded, but I don't really see being 1psi low as making a huge difference to stability.
It certainly wasn't "wobble of death", wobble of death, if you ever experience it, is an unforgettable event - a violent shaking of the steering wheel, and only to get out of it, is to bring the vehicle to a stop.
What you're describing sounds more like a top heavy vehicle, they tend to "wallow" as you steer into the sway, you're always lagging the event, I have experienced something similar but not a Jimny.
60mph. First time it happened I probably had 30kg on the roof, but after the first time it happened I reduced that down to about 15kg. I've certainly not removed any sway bars, will have a look at the various connect-y bits, although not sure I'll spot if they're knackered! Tyres are 215/75R15 Yokohama Geolander G015 A/T, have had them on for about 5 years and had runs to Scotland and Switzerland with no issue.
Could radius arm bushings be a cause? Had my dad rocking the car and there looked to be a lot of flex in the rear drivers side bushing, unsure if the amount is normal or not.
Please Log in or Create an account to join the conversation.
- Roger Fairclough
- Offline
- Platinum Member
-
Registered
- Posts: 1457
- Thank you received: 210
Roger
Please Log in or Create an account to join the conversation.
Could radius arm bushings be a cause? Had my dad rocking the car and there looked to be a lot of flex in the rear drivers side bushing, unsure if the amount is normal or not.
This is certainly worth investigating - what do you mean by rear drivers side bushing?
On each side of the car, there will be two radius arms, front & rear, each with three bushings, two at the axle end, one at the frame end - I don't think there should be enough flex in any of them to be noticeable simply rocking the vehicle, and the axle end bushings do come under a fair bit of twisting if/when the vehicle is used off road.
Please Log in or Create an account to join the conversation.
- Posts: 9048
- Thank you received: 1811
Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
ADOS Attention Deficit Ooooh Shiny!
Please Log in or Create an account to join the conversation.
Sent from my ThinkPhone by motorola using Tapatalk
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Please Log in or Create an account to join the conversation.
- Rogerzilla
- Offline
- Premium Member
-
Registered
- Posts: 83
- Thank you received: 11
That's not really the ideal use case for a Jimby, though.
Please Log in or Create an account to join the conversation.
- Posts: 1900
- Thank you received: 491
However, I was a tad late the other day so cruised along the main A road near me at 65-70mph, there was a noticeable wobble in the steering wheel, but even relaxing my grip the car didn't wander. It is possibly a wheel balance or tyre pressure thing. Once I got on to the A1(M) at 65-70mph, the wobble was hardly there so it might have been a more worn surface on my local A road.
Anyway I am not bothered, I don't often travel above 60mph and all the way to BigJimny and back at similar speeds, I never noticed it.
Gadget, perhaps what you noticed was just more extreme form of what I noticed, but the extra weight on yours made it worse?
Robin
2020 blue SZ5 (one of the last to be registered in the UK)
Ex 2011 Blue Jimny SZ4
Northumberland Jimny Blog
Please Log in or Create an account to join the conversation.
- Posts: 1900
- Thank you received: 491
Having gone from a Gen 3 (2011) to a Gen 4 (2020) earlier this year, I find my Gen 4 much more suited to faster roads, it's running the exact same tyres as I swapped them from my Gen 3 to Gen 4 when I changed car.The gen4 isn't great above 60mph. It's nervy, noisy, and the fuel consumption is tragic. The gen3 was more suited to 70mph cruising.
That's not really the ideal use case for a Jimby, though.
My Gen 4 has a lot more power for faster cruising and I find the Gen 4 much more stable. Fuel consumption takes a hit, but I average nearly 40mpg in the Gen 4 (mostly slower roads) whereas I could only manage 33mpg in my Gen 3. If I was to drive at 70mph and check fuel economy it would dip, but I am willing to bet it is still higher than my old Gen 3.
I don't often go on the motorway/fast A roads and then keep the speed under 60mph.
Robin
2020 blue SZ5 (one of the last to be registered in the UK)
Ex 2011 Blue Jimny SZ4
Northumberland Jimny Blog
Please Log in or Create an account to join the conversation.