A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
Hi. I am looking for the specified tightening torque for the exhaust manifold bolts and nuts for the Jimny Gen4 JB74.
Are the values the same for both the bolts and nuts?
I do not have the workshop manual so would appreciate these values as I am about to fit a different manifold.
Regards Gerrit
Main manifold bolts and nuts - 60Nm
Stiffener bolt and nuts - 25Nm
The stiffener is the bracket at the neck of the manfold to engine block
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
