A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Right,Fog lamps wired up and working, used the 3rd party wiring/relay etc, looked to be too much of a hassle to try and utilised the loom, if the connectors were there??
BUT, can anyone tell me if I use the original suzuki switch, which pins to use on it!!
The switch with the kit uses 3 wires, one is an earth, one from the relay, and the last which links into the dipped beam circuit,the suzuki switch has five pins, , I'm afraid looking at the wiring diagram is a bit beyond me to fathom where this is concerned.
Cheers
Alan
The switch is shown in the second manual I sent over.
Pins 5 and 6 are the +ve feed, these are wired to the lighting circuit in the Jimny as you are not allowed to have the fog lights on without having the lights on. Pin 6 is just the feed to illuminate the switch, pin 5 is the power that goes through to the fog lamps.
Pins 1 and 2 are earths.
Pin 4 is the output to the fog lamp relay.
Martin
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Martin,
sorry to be a pain, but could you tell me, if I have only 3 wires from the 3rd party wiring I have,
1. from the relay
2. from the sidelight circuit
3. an earth
which pins on the suzuki switch do I use, does this make sense??
Cheers
Alan
1. From relay >> Pin 4
2. From sidelight circuit >> Pins 5 and 6 (connect to BOTH)
3. Earth >> Pins 1 and 2 (connect to BOTH)
Martin
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
