A place for more technical discussions. Please make sure you post in the correct section on the site, this way it keeps the site tidy AND ensures you get a more relevant answer.
jimny engine !
05 Oct 2008 09:40 #213
by mlines
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Replied by mlines on topic Re:jimny engine !
The engine itself will be the same. The flywheel and clutch assembly will need removing from your old engine and putting on the new engine. Depending on how much is still attached to the new engine (did you get the auto gearbox - can I have it 
) you will probably have a plate and torque converter where the flywheel goes. You will have to strip these off the new engine.
Martin
) you will probably have a plate and torque converter where the flywheel goes. You will have to strip these off the new engine.Martin
Martin
2003 M13 early KAP build.
3" Trailmaster lift with 1.5 Spacers on front
Customised winch bumper and roll cage
235/85R16 Maxxis Bighorns on 16" Rims, 4:1 Rocklobster, Rear ARB locker and on-board air
Corrected arms all-round, rear disks, Recaro seats and harnesses
Please Log in or Create an account to join the conversation.
Time to create page: 0.263 seconds