no longer required, thanks. WTD- centre console gear surround

Hello. Does anyone have the centre console piece that goes around the gear stick and towards the dash?

I’m about to install an amateur radio but to get a neat job I’ll need to modify this panel to suit and me being me I’d rather I kept the original mint or at least have a replacement part to hand if I ever change my mind.

The cheaper the better please as it’s only for a spare but also in as good a condition as poss. If you’re not in centra Scotland I’d happily pay for myhermes or the like for postage.

Thanks in advance
Tony.


Sent from my iPhone using Tapatalk

Airbag controller is under there, not a lot of room to be gained from chopping it up im afraid.

There is enough space to screw into the plastic under the ashtray to have a bracket holding the CB from above, roughly where you have it in the picture (thats how mine is mounted, but my CB is a lot smaller than that one).

I might have a console what year is yours ?
You could relocate cb in to glove box

Hi cheers for replying.

My Jimny is a 2008 with push button 4wd.


I’ll need to look under it then to see if shaving it will make any difference or not I don’t need a massive cut (I think)

I did think about the glove box too but I liked the idea of it being console mounted



Like the way I’m holding it here just further back into the dash. I’ll try and have a look Monday after work and try to figure out if my trim would interfere with the important abs thingy.


Sent from my iPhone using Tapatalk

This is the bit I had intended to shave/ trim off. Roughly along the yellow cut line.



Sent from my iPhone using Tapatalk

I had intended to do something similar but different with mine. There's literally a 4 or 5 mm clearance of the abs module under the plastic. Sorry.