Door open buzzer

From BigJimny Wiki
Revision as of 13:03, 26 September 2019 by Bosanek (talk | contribs) (Expanded the article to contain info for the seat belt disconnected buzzer)
Jump to navigation Jump to search

Note Icon.pngThe content of any article might be expanded / improved in the future - revisit it sometimes.
Note Icon.pngSeen a mistake? Know something that isn't written? Edit and change this article yourself!
Note Icon.pngSome images in the article (if present) can be enlarged by clicking on them.


Introduction

Gen3-100x100.jpg


Gen4-100x100.jpg


Later Jimnys 3 and all Jimnys 4 sound an audible warning tone when the key is in the ignition and a door is ajar, and also when one of the front seat belts are disconnected in some situations.

These warning tones can become annoying when working on the vehicle, but can be silenced by disconnecting some electrical plugs.


Tools needed

Gen3-100x100.jpg


Gen4-100x100.jpg


For the door open buzzer

  • #2 Philips screwdriver
  • Electrical insulation tape


For the seat belt disconnected buzzer

  • More info is needed ...


Procedure for the door open buzzer

Gen4-100x100.jpg


Steering column trim removal

To remove the steering column trim:

Gen4 wiper2.jpg
  • Underneath the steering column, locate the single retaining screw (in the deeply recessed hole adjacent to the steering wheel heigh adjustment lever).
  • Remove this screw using a #2 Philips screwdriver.



Gen4 wiper3.jpg
  • Release the steering while height adjustment lever (this provides clearance to remove the lower half of the steering column trim.
  • The steering column trim lower is secured to the upper with plastic clips on each side.
  • To release, push the lower half of the trim inwards and pull downwards.
  • The photo below shows the exposed clips.
  • Having released the clips on each side, remove the lower half of the trim, carefully pulling over the ignition key barrel and steering wheel adjustment lever.



Disconnecting the wiring

Gen4 doorbuzzer.jpg
  • Disconnect the two pin plug shown above from the indicated socket by depressing the catch on the far side of the plug and pulling towards the engine bay.
  • Cover the end of the plug in electrical insulation tape to prevent any possible short circuit and tape the plug to a suitable location to prevent it from rattling.


Re-assembly

  • Replace the steering column trim by reversing the removal steps above.
  • Enjoy life with one less nagger around you.


Procedure for the seat belt disconnected buzzer

Gen4-100x100.jpg


Someone needs to incorporate info from the forum discussions ...


Separate notes for Jimny 3

Gen3-100x100.jpg


According to one forum report, in Jimnys 3 which have the door open buzzing "issue", there's a connection under the steering column that has green and white wires, which needs to be disconnected. More info on this is needed. The silencing procedure is quite similar as the one described for Jimny 4.


Related forum discussions

Gen3-100x100.jpg


Gen4-100x100.jpg


The following forum discussions contain useful info regarding these issues:



Page last edited on 26/09/2019 by user Bosanek