Difference between revisions of "BigJimny Wiki talk:General disclaimer"
(→Jimny Jb74 Gen4 CV Joints: new section) |
(→G13bb engine: new section) |
||
Line 18: | Line 18: | ||
Thanks all | Thanks all | ||
+ | |||
+ | == G13bb engine == | ||
+ | |||
+ | Gooday iv have recently cracked my block on my 1998 g13bb jimny and I’m after a new motor little did I no trying to find one was a lot harder than first thought.found a couple for a ridiculous price and don’t see the sense in spending 3.500 k on a car that’s worth 4k.all other engines components are mechanicaly fine on my rig so now I’m wondering if I can swap a g13b block with the top components of my original g13bb.iv read that the g13b) and the g13bb blocks are identical.has anyone done this ? Or has an alternative or some one that can point me in the right direction?? |
Latest revision as of 10:46, 4 September 2023
hello, when i accelerate in my 2003 jimny there is a clanking noise and when it dose 65 to 75mph it vibrates quite harshly, the jimny has done about 47000 miles. i went under the car to have a look and took some videos
https://youtube.com/shorts/mcXwGBplI1E?feature=share
https://youtube.com/shorts/9JQylD-ES9o?feature=share
Jimny Jb74 Gen4 CV Joints
Hello everyone,
My CV joints on both axles have failed causing damage to the shaft axle and all need to be replaced now. Also my rear diff oil started leaking from the drums.
It's 2019 with 59,000 km (around 37K miles)
Another car in my town is facing the same problem.
Is anyone faced similar problem, isn't weird to face these issues for a new car?
Thanks all
G13bb engine
Gooday iv have recently cracked my block on my 1998 g13bb jimny and I’m after a new motor little did I no trying to find one was a lot harder than first thought.found a couple for a ridiculous price and don’t see the sense in spending 3.500 k on a car that’s worth 4k.all other engines components are mechanicaly fine on my rig so now I’m wondering if I can swap a g13b block with the top components of my original g13bb.iv read that the g13b) and the g13bb blocks are identical.has anyone done this ? Or has an alternative or some one that can point me in the right direction??