|
|
| Line 1: |
Line 1: |
| − | {{intro-notes}}
| + | This article is obsolete and has been removed. |
| | | | |
| − | {{embryo-note}}
| + | Instead, two new separate articles have been created (one for front speaker upgrade and the other for rear speaker installation) in the corresponding wiki sections. |
| | | | |
| − | | + | Find the replacement articles in the wiki. |
| − | == Introduction ==
| |
| − | | |
| − | | |
| − | Jimny has only two weak and dull front speakers.
| |
| − | | |
| − | However, it has pre-machined space for a pair of rear speakers as well, as well as part of the wiring for them installed from the factory.
| |
| − | | |
| − | | |
| − | If you replace the front speakers with something good, and install a pair of good rear speakers, you will get a significantly improved sound (nothing "boombastic", just solid and proper).
| |
| − | | |
| − | | |
| − | == Solutions ==
| |
| − | | |
| − | | |
| − | Links:
| |
| − | * [https://www.danbp.org/p/en/node/103 '''Installation guide for front speakers''']
| |
| − | * [https://www.danbp.org/p/en/node/104 '''Installation guide for rear speakers''']
| |
| − | | |
| − | | |
| − | == Recommended additional works ==
| |
| − | | |
| − | | |
| − | While you are having the side doors' trim dismantled in order to install the front speakers, you might use the opportunity to perform some additional works along the way:
| |
| − | * Installation of [[Sound insulation and vibration damping|'''sound insulation and vibration damping''']] materials in the side doors;
| |
| − | ** This also improves the performance of in-door speakers;
| |
| − | * [[Rust protection|'''Rust protection''']] of the door cavities through the application of wax for example;
| |
| − | * Re-greasing of side door window operating mechanisms;
| |
| − | | |
| − | | |
| − | While you are having the rear interior of the car dismantled in order to install the rear speakers, you might use the opportunity to perform some additional modifications along the way:
| |
| − | * Installation of [[Sound insulation and vibration damping|'''sound insulation and vibration damping''']] materials in the rear part of the cabin;
| |
| − | ** This will also improve the performance of rear speakers;
| |
| − | * [[Rust protection|'''Rust protection''']] of the body cavities through the application of wax for example;
| |
| − | * [[Rear cabin lamp installation|'''Rear cabin lamp installation and wiring''']];
| |
| − | * Installation of wires for rear parking sensors, tow bar, rear reversing camera, concealed GPS tracking unit, 12 V DC charging outlet in the trunk, whatnot, etc.
| |
| − | | |
| − | | |
| − | == References ==
| |
| − | | |
| − | | |
| − | Until this article gets properly written, gather some more knowledge at the following forum topics:
| |
| − | * [http://www.bigjimny.com/index.php/forum/7-jimny-technical/37772-speakers#37818 Speakers];
| |
| − | | |
| − | | |
| − | {{Edited}}
| |
| − | | |
| − | [[Category:Infotainment - gen3]]
| |
| − | [[Category:Accessories - gen3]]
| |
This article is obsolete and has been removed.
Instead, two new separate articles have been created (one for front speaker upgrade and the other for rear speaker installation) in the corresponding wiki sections.
Find the replacement articles in the wiki.
