BigJimnyMeet (North) 2024 (12 Jan 2024)
14th July 2024
Parkwood Nr. Leeds
Click HERE for details
Cable entry from engine to cabin ?
- Blackout
- Topic Author
- Visitor
-
Public
Please Log in or Create an account to join the conversation.
- Posts: 8787
- Thank you received: 1754
- Points: 36113.00
Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
ADOS Attention Deficit Ooooh Shiny!
Please Log in or Create an account to join the conversation.
- Blackout
- Topic Author
- Visitor
-
Public
Please Log in or Create an account to join the conversation.
- jackonlyjack
- Offline
- Platinum Member
-
Registered
- Posts: 2906
- Thank you received: 650
- Points: 8431.00
After that i drilled a hole and used a cable gland
Please Log in or Create an account to join the conversation.
- Posts: 8787
- Thank you received: 1754
- Points: 36113.00
Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
ADOS Attention Deficit Ooooh Shiny!
Please Log in or Create an account to join the conversation.
- Blackout
- Topic Author
- Visitor
-
Public
Please Log in or Create an account to join the conversation.
- jackonlyjack
- Offline
- Platinum Member
-
Registered
- Posts: 2906
- Thank you received: 650
- Points: 8431.00
use a paper clip but first make it flat using a hammer then push it down from the front and pull steady on the wires
Please Log in or Create an account to join the conversation.
- Posts: 1727
- Thank you received: 468
- Points: 10914.00
Black 2019 Jimny SZ5
www.bigjimny.com/index.php/forum/8-my-ji...ley-s-2019-black-sz5
Please Log in or Create an account to join the conversation.
- Posts: 8787
- Thank you received: 1754
- Points: 36113.00
Soeley wrote: When I fitted a temp gauge to my last car I had to get the sensor end through a similar grommet. So I used a sealant nozzle and some WD40, it went in like a hot knife through butter.
That's clever. I'm stealing this idea for the future.
Temeraire (2018 quasar grey automatic)
One of the last 200ish of the gen3s, probably.
ADOS Attention Deficit Ooooh Shiny!
Please Log in or Create an account to join the conversation.
- Blackout
- Topic Author
- Visitor
-
Public
Please Log in or Create an account to join the conversation.
- Podge
- Visitor
-
Public
You can push it through from the engine bay but my grommet had a tape seal on the inside which wouldn't let the grommet stretch and the cable been pushed through. Once it was off it was easy to push the cable through .
Please Log in or Create an account to join the conversation.
- Posts: 1727
- Thank you received: 468
- Points: 10914.00
Blackout wrote: That’s a great idea! Did you have to cut the grommet? I have fear of nicking one of the wires as I cut, guess I could pull it back a bit
I just punched through first with a small electricians screwdriver.
Black 2019 Jimny SZ5
www.bigjimny.com/index.php/forum/8-my-ji...ley-s-2019-black-sz5
Please Log in or Create an account to join the conversation.