BigJimny Wiki talk:General disclaimer

From BigJimny Wiki
Revision as of 10:46, 4 September 2023 by Haydothompson97 (talk | contribs) (→‎G13bb engine: new section)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

hello, when i accelerate in my 2003 jimny there is a clanking noise and when it dose 65 to 75mph it vibrates quite harshly, the jimny has done about 47000 miles. i went under the car to have a look and took some videos

https://youtube.com/shorts/mcXwGBplI1E?feature=share

https://youtube.com/shorts/9JQylD-ES9o?feature=share

Jimny Jb74 Gen4 CV Joints

Hello everyone,

My CV joints on both axles have failed causing damage to the shaft axle and all need to be replaced now. Also my rear diff oil started leaking from the drums.

It's 2019 with 59,000 km (around 37K miles)

Another car in my town is facing the same problem.

Is anyone faced similar problem, isn't weird to face these issues for a new car?

Thanks all

G13bb engine

Gooday iv have recently cracked my block on my 1998 g13bb jimny and I’m after a new motor little did I no trying to find one was a lot harder than first thought.found a couple for a ridiculous price and don’t see the sense in spending 3.500 k on a car that’s worth 4k.all other engines components are mechanicaly fine on my rig so now I’m wondering if I can swap a g13b block with the top components of my original g13bb.iv read that the g13b) and the g13bb blocks are identical.has anyone done this ? Or has an alternative or some one that can point me in the right direction??